速度切位置运动(中断定长)

该功能可用于皮带送料，先启动速度运动一直运行，通过输入信号检测到产品之后切换成相对运动。

RetCode result;
int exit_cmd = 0;
UINT32 axisIndex = 0;
UINT32 axisIndex = 0;

//库加载
result = YKM_LoadLib();
YKM_BusInfo busInfo;

//等待系统初始化完成
while (!exit_cmd)
{
  result = YKM_GetBusInfo(&busInfo);
  if (busInfo.running)
    break;
  Sleep(100);
}

//设置相对运动参数
YKM_MoveRelativeConfig moveRelativeCfg;
memset(&moveRelativeCfg, 0, sizeof(YKM_MoveRelativeConfig));
moveRelativeCfg.distance = 200;
moveRelativeCfg.acceleration = 1000;
moveRelativeCfg.deceleration = 1000;
moveRelativeCfg.jerk = 10000;
moveRelativeCfg.velocity = 100;

//设置速度运动参数
YKM_MoveVelocityConfig moveVelocityConfig;;
moveVelocityConfig.direction = YKM_DIRECTION::YKM_DIRECTION_POSITIVE;
moveVelocityConfig.acceleration = 1000;
moveVelocityConfig.deceleration = 1000;
moveVelocityConfig.jerk = 10000;
moveVelocityConfig.velocity = 50;

//设置输入信号参数
UINT32 byteIndex = 0, bitIndex = 0;

//速度运动
result = YKM_MoveContinuesVelocity(axisIndex, moveVelocityConfig, YKM_BufferMode::YKM_BLENDING_PREV);
print(result);

//输入信号，收到输入信号后切换到下一条指令中去
result = YKM_MoveContinuesInput(axisIndex, byteIndex, bitIndex, YKM_TrigMode::YKM_TRIGMODE_UPEDGE);
print(result);

//相对定位
result = YKM_MoveContinuesRelative(axisIndex, moveRelativeCfg, YKM_BufferMode::YKM_BLENDING_PREV);
print(result);

YKM_MoveContinuesStart(axisIndex);

//等待目标位置到达
YKM_AxisStatus status;
while (!exit_cmd)
{
  result = YKM_ReadAxisInfo(axisIndex, &status);
  if (0 != status.Done)
    break;
  Sleep(1);
}